Elite Screens R135WH1 Guide de l'utilisateur télécharger pdf (Page 7)

Attaching the Fix Plates___

1. Make sure that the material and frame are both laying face down on a clean, dry and non-abrasive

surface.

2. Center the material inside the frame.

Please note the material will be noticeably smaller because stretching the material is required to create

a sufficient amount of tension for perfect material flatness.

3. Start attaching the fix plates in the center of the long horizontal edge and (1) then alternate with the

center short sides (2) as shown in diagram (fig.7).

Note: Follow these instructions to make sure the material is properly fixed in the center position of the

frame. After attaching the fix plates in sequence #2 (the center of the short sides), please remove the fix

plates in sequence #1 (the center of the long horizontal edge) and reattach them again, and also remove the

fix plates on sequence# (2) and reattach them again.

4. Then continue to follow our recommended order numbers 3-8 to properly distribute tension to the

screen material.

Center Support Bard

1. Insert the support joiner into each side of the center support bar to complete assembly.

support joiner

Center support bar

2. Insert the Center Support Bar into the groove on the back of the frame with the bottom end near the

approximate center point of the frame and place it in at an angle so that both ends of the bar are in

alignment with the groove. (see Fig. 8 below for details).

(6)

(Fig. 7)

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Elite Screens R135WH1 Guide de l'utilisateur Page 7